Nad Phono Preamp Pp2 Manual Page

The PP 2 utilizes high-quality components and a 24V power supply for enhanced musical dynamics and stability. Moving Magnet (MM) Moving Coil (MC) Gain at 1kHz Input Sensitivity 3.5mV (ref. 200mV output) 0.2mV (ref. 200mV output) Signal-to-Noise Ratio 80dB (A-weighted) 78dB (A-weighted) RIAA Accuracy ±0.3dBplus or minus 0.3 d cap B ±0.3dBplus or minus 0.3 d cap B THD (20Hz - 20kHz) Source: NAD PP-2 Specifications . 3. Troubleshooting

Move the PP 2 away from other equipment (like power transformers) to reduce interference.

: If your turntable has a separate ground wire, secure it to the GND thumb screw on the back of the PP 2 to minimize hum. Nad Phono Preamp Pp2 Manual

Check if the . If not, verify the power supply connections. Ensure the correct input is selected on your amplifier. Hum or Buzz :

: Check that all RCA plugs are fully inserted into their respective sockets on both the PP 2 and the amplifier. The PP 2 utilizes high-quality components and a

: Toggle the rear MM/MC switch to match the input you used.

Plug your turntable's RCA leads into the or MM inputs on the back of the PP 2, depending on your cartridge type. Match the colors: Red for Right (R) and White for Left (L). : If your turntable has a separate ground

: Verify that the PP 2 is connected to a standard Line-Level input and not a Phono input on your receiver. Phono Preamplifier PP 2 - HiFi Gear